Questions tagged [hydronic]

62 questions
4
votes
4 answers

How to install hydronic radiant heat over concrete slab

I'm trying to figure out the most ideal way to install hydronic radiant heat in my basement over the existing concrete slab. I've looked at several products for heat distribution, like Warmboard, before settling on this:…
vlozko
  • 87
  • 1
  • 3
  • 8
3
votes
1 answer

Radiant heated floor makes noise after adding additional 1/2" of plywood

I have installed hydronic radiant heat pipes under the subfloor; used aluminum plates for spreading the heat from pex pipes. The house is old, I think the original subfloor is 5/8 Douglas fir. Up to this point, everything was fine, the flow was not…
Tomas
  • 51
  • 4
3
votes
1 answer

Hydronic heating not working, but have hot water

I have a Navien combo-boiler system with two hydronic baseboard heating loops hooked up to it. Our on-demand water heating (showers, etc) are working fine. Both heating loops however, are not. I have both thermostats set to 70, but the main floor is…
Havegooda
  • 173
  • 1
  • 8
3
votes
0 answers

Help me Understand Hydronic System Boiler Circulator RPM / HP / Head / Flow / System Pressure

Help me understand the correlation between boiler circulator RPM / HP / Head / Flow / System Pressure - see the particulars at the bottom. CASE: My 1986 boiler came with Armstrong S25 circ (same as B&G 100). When the circ failed I replaced it in an…
Roz
  • 51
  • 4
3
votes
1 answer

Anyone installed a hot water coil in their HVAC ductwork to increase heat pump efficiency?

Hydronic heat supplement to Heat pump Home heating System. Anyone have experience putting a heating coil in the ductwork of a forced air heat pump system? Background. The existing HVAC system is a heat pump with auxiliary electric heat strips. I am…
user67651
  • 31
  • 1
  • 2
2
votes
1 answer

Hydronic heat radiators not used for long time - should they be drained?

What should I do with radiators that have been out of action for about 3 years since the boiler went on the blink? Is it better to drain the water out of the system while system is dormant?
2
votes
1 answer

Critique my Radiant Hydronic Heating Plan

I'm planning to install radiant heating lines in my new "studio" (essentially a detached garage). I want to save some money by doing parts of the project that I feel confident with. I think I can design and install the PEX tubing for hydronic…
Jeremy Foster
  • 221
  • 1
  • 2
  • 11
2
votes
5 answers

How to balance hot-water heating system when farthest radiator stays cold

Is there a counterpart to the advice given in this video except for late 1940s-era convector-style radiators which do not have a valve on their return and have only an air-bleed-valve? Basically a pipe with fins arranged around it. The convector…
mr blint
  • 996
  • 10
  • 24
2
votes
1 answer

Is there a way to have one thermostat control a heat pump and a 3 zone hydronic system?

I have two heating systems that are independent of each other. One is a 3 zone hydronic system with 3 thermostats controlling a pump controller. The second system is a air to air heat pump without any form of back up heat. When temp's get to low…
2
votes
1 answer

Grundfos Alpha pump shows 0 GPM but consumes power and heating works?

I have some heating zones which run off a Grundfos Alpha pump which is set to the "auto" mode. Heating seems to work fine - rooms heat up normally and this doesn't seem to take an unusually long time. However I noticed that when the pump is on and…
StayOnTarget
  • 5,286
  • 14
  • 43
  • 83
2
votes
2 answers

Is this typical for how hot water heating loops are plumbed?

First time owning a home with hot water heat, and studying the plumbing the basement, I notice that the living room/kitchen zone that has a run of baseboard, a kick panel unit, and several floor units, doesn't have them daisy chained as I expected,…
TomG
  • 3,928
  • 2
  • 24
  • 40
2
votes
1 answer

Can’t shut off power to heat-only (hydronic baseboard) thermostat

I have no AC in my condo, only hydronic baseboard heat, currently controlled by an old mercury thermostat. I have a new smart thermostat with a c-wire adapter I want to replace it. Trouble is, I’ve switched every darn switch on the panel (as far as…
2
votes
3 answers

Can I replace hydronic water boiler return pipes with pex?

My house was built in the 1920s, the heating source was a hot water/radiator system. Originally the basement was probably used only for a coal furnace (we have the drop-off door that the coal guy used to deliver through). We are looking at putting…
rajan
  • 163
  • 1
  • 7
2
votes
0 answers

How to remove a Honeywell Braukmann 104v radiator actuator

I have a radiator with a Honeywell 104V radiator actuator that I'd like to replace, I think it's P/N T104V1422. I can't seem to figure out how the thing is connected to remove it. The rest of the house uses 104A actuators which have a locking ring…
Arcane2784
  • 21
  • 1
1
vote
0 answers

Hydronic Heating: Noisy pipes in the basement/walls

My issue is i have a natural gas boiler + hydronic heating system (two zones). It seems that after I remove air from each zones, the heating system is quiet until 12 hours later. In the early morning , we hear knocking in the basement/ first floor…
xyy 844
  • 11
  • 1
1
2 3 4 5