Home Improvement Stack Exchange
Home Improvement Stack Exchange

Questions tagged [bypass]

7 questions
5
votes
2 answers

Bypassing an inverter using manually operated switch

I am in the design process phase of a home project where I will be adding a hybrid solar inverter and battery storage into my home setup. We will not be connecting a solar PV array. The goal is to charge the batteries during the off-peak "cheaper"…
Paul Evans
  • 127
  • 3
3
votes
1 answer

Can I route a copper pipe bypass like this (and drill a stud)?

I finally found the water leak in my condo. I cut and cap a 1/2in pipe and the hissing sound of water went away. Now I have to figure out how to install a bypass because I lost the cold water in both the bathrooms sink. I still have hot so no hurry…
Rodo
  • 465
  • 1
  • 6
  • 20
1
vote
3 answers

gcfi tiled over during bath remodel

I think my contractor may have covered up the GFCI behind the tile in a bathroom remodel several years ago. It has been fine all this time, but recently my wife was dying her hair and popped the circuit from an outlet in another bathroom in the same…
Brent Hilvitz
  • 11
  • 1
0
votes
1 answer

dual-end powered ballast bypass with fixture that has a built in switch

I am attempting to do a ballast bypass for LED tube lights. The LED bulbs are dual-end powered with just one bulb per fixture. The pictures showed the wires I have at the ballast. The black wire on the left is from the switch, which is from the…
onmyown
  • 3
  • 1
0
votes
1 answer

Do small parallel bypass switches for electrical panel exist?

I would like to install ethernet commanded relays between the breakers and the "house" (relays ref https://www.dingtian-tech.com/en_us/relay8.html#). However, I would also like to bypass the relays when I'm home, so I want to install bypass…
Florian S.
  • 3
  • 1
0
votes
0 answers

How can I bypass the motion sensor on a Handy-Brite solar flood light?

I need to rewire a solar flood light so that when the switch is in the "on" position, the flood light remains on continuously being shut off at the switch. In the "off" position, the flood light would operate as intended, being activated by nearby…
R.Steph0403
  • 1
  • 1
0
votes
1 answer

Water feed pipe diameter: is 1/2" OK?

The 3/4" water feed in a slab has a leak. A proposed bypass includes a 1/2 inch PEX, run through the ceiling. Why should a 1/2 inch PEX be used to bypass and not a 3/4 inch? Assume that the slab pipe and the PEX pipe are the same length.
gatorback
  • 2,976
  • 6
  • 26
  • 51