Questions tagged [valve]
545 questions
26
votes
5 answers
Are "1/4 turn" water supply valves more reliable than "multi-turn" valves? Or vice-versa?
Aside from personal preference, is there any reason why I would want to buy a "1/4 turn" water supply valve instead of "multi-turn valves"? Is one technology/design clearly superior than the other in terms of reliability? Or is this purely just a…
Mike B
- 8,011
- 53
- 107
- 147
14
votes
3 answers
Is it safe to have a drain in the floor out to the septic tank with no trap?
I had a contractor add an additional bath. When we were planning out the project, he mentioned my lack of a water heater valve drain pan. Instead, he installed a drain directly into the septic line that runs from the new bathroom (toilet/sinks/tub)…
Austin Seward
- 199
- 1
- 6
13
votes
3 answers
How can I add valves to supply lines when the lines are soldered to the faucet?
I am trying to replace an old faucet that my 3 yo child is unable to use because of its design. I'm new to plumbing but actively reading. I haven't seen these supply lines w/o valves before. This looks like the pipes are going straight into the…
eszed
- 477
- 2
- 7
- 17
13
votes
1 answer
Can't find a garden hose that fits
Just moved into a new house and the spigot the in backyard is too big for the hose I bought. Is there an adapter or a special hose that can fit this?
Mishelle
- 133
- 1
- 1
- 5
11
votes
4 answers
What causes a water heater's relief valve to discharge water?
I have a Gas Reliance Water Heater 1212. I found recently (in winter) there is a water dip through the relief valve into a 5 gallon bucket. Sometimes, it can fill the whole bucket. Sometimes, it has no water drip at all.
I can't find the reason why…
Richard Sayakanit
- 327
- 1
- 4
- 15
10
votes
8 answers
Do brass ball valves have to be oriented with the flow of water?
I bought this brass ball valve from Home Depot and installed it in the orientation of what I would consider "backwards". I'm not sure if it actually matters and before I close up the wall I would like to make sure orientation isn't an issue with…
Joe Phillips
- 2,145
- 11
- 39
- 57
10
votes
4 answers
Installer won't install dishwasher due to "old" stop valve
We just ordered a new Bosch dishwasher from Home Depot, including third-party installation. The installer they sent looked under the sink and said that because our stop valve is too old, that he could not do the installation "through the company". …
homejoker
- 131
- 2
- 8
9
votes
2 answers
What is the purpose of the valve between these two pipes?
I saw an interesting arrangement of pipes and valves in a house I visited. These are hot water pipes, the two vertical pipes connect to a radiator. What is the purpose of the valve between the two vertical pipes? I don't see how this could do…
Mike Mertsock
- 193
- 6
9
votes
1 answer
Temperature Pressure Release (TPR) Valve Leaking
Check out the evolution of my saga with my water pressure and my water heater here:
Water Pressure Regulator not regulating after rebuild
And here:
High water pressure when gauge is not observed
Never had any issue with Temperature Pressure Release…
SDSHuge2.0
- 349
- 9
9
votes
8 answers
How do I pressure test a natural gas line and what do the valve pressure ratings mean?
I'm planning to add an appliance to my house, and will want to do a pressure test of the newly installed gas lines. My main shutoff says 175 PSI, but most of the appliance valves say either 1/2 or 5 PSI. Finally, I see a Nibco valve at my local…
Pigrew
- 3,405
- 2
- 22
- 30
9
votes
2 answers
How to remove this water shut off valve under the kitchen sink?
I'm trying to remove the sink cabinet but I'm stuck at these water shut off valves and the escutcheons.
Water is off already. Tried to use a wrench but didn't seem to do much.
Steven
- 131
- 2
8
votes
4 answers
Handheld showerhead backflow preventer
Every year my rental house is inspected by the city. Last time the inspector told me to add a backflow preventer (one-way check valve) to the handheld showerhead in the bathroom. The showerhead is on a long enough hose that it could be submerged…
Carl Raymond
- 193
- 1
- 1
- 4
8
votes
3 answers
How do I find the water main entry point to my house?
My house has no apparent main water line shut off valve. Usually one would find a shut off valve right near where the water main entered the house structure. At my current house I have never been able to determine where the water main entry point is…
Michael Karas
- 63,732
- 7
- 60
- 141
8
votes
4 answers
Corroded Water Shut Off Bolt/Lever - Is this okay for now?
A couple months ago I noticed our water pressure get weaker when we used more than one appliance in the home. Today I picked up a replacement PRV but when I went to change them out I noticed that the lever to shut the water off to the home has some…
urpaltuck
- 81
- 2
7
votes
1 answer
No water after reopening main water valve
I closed the main water valve for simple repairs. After reopening it there's barely any water doesn't even register in the meter. The valve doesn't feel broken but I can't think of what could be wrong.
The solution:
Our main shutoff valve is a small…
user2951