Home Improvement Stack Exchange
Home Improvement Stack Exchange

Questions tagged [patching-drywall]

Advice about the repair of drywall. Use with the [drywall] tag

207 questions
29
votes
6 answers

How should I support this large drywall patch?

after the installation of a new water heater and a relatively extensive plumbing fix, I wanted to save a buck trying to patch the drywall myself. It's the very first time I buy a piece of drywall or anything related to this activity. I re-created a…
Alessio Sangalli
  • 663
  • 11
  • 17
29
votes
5 answers

What is the best method to patch a large hole (2-3 inches) in drywall?

I have a large hole where a TV wall mount once was (I believe the hole was used to run power and coax cable to the TV). I have since moved the TV and would like to patch the hole. What is the best way to do this?
mmattax
  • 391
  • 1
  • 4
  • 4
21
votes
7 answers

How do I mount this towel rack that was ripped off the wall?

Hi one of my tenants sent me a pictures of my broken towel rack. What would be the most cost effective fix?
Sharif Bhuiyan
  • 311
  • 1
  • 2
  • 3
19
votes
9 answers

How big a hole in drywall can be fixed by spackle alone?

How big of a hole in drywall can be fixed by spackle alone? The previous owners left numerous holes in the drywall. Each hole is the diameter of a coaxial cable, which I want to patch up. Can I use spackle to bridge the gap? Or can I press fit a…
pkumar
  • 391
  • 1
  • 2
  • 4
17
votes
11 answers

How to cut drywall over stud?

Let's say I have a hole like this (not my actual hole just one that I found for my situation) As you can see the existing drywall is flush with the 2x4. What I want to do is cleanly cut away enough of the existing drywall (about an inch) on both…
Dean MacGregor
  • 768
  • 3
  • 9
  • 22
16
votes
7 answers

How to reduce drywall hole size

I want to run network cable into a bedroom and was going to use one of those Low Voltage Wall plate and cat 5E wall plate over it. While trying to install low voltage wall plate, instead of tracing inner sides I traced outer sides and cut a wider…
Siva
  • 189
  • 3
  • 7
15
votes
7 answers

How can I fix a towel bar pulled from the wall?

My father-in-law leaned on the towel bar to rise from the toilet, which ripped both sides out of the wall. The holes are pretty large, almost an inch on one side, and this is the second time it's been repaired (originally with mesh tape on the right…
Elizabeth Tull
  • 151
  • 1
  • 3
14
votes
4 answers

Re-painting drywall after patching leaves tones

I patched a few scrapes and small holes in the drywall, then got a can of color-matched paint in the hardware store (I took a sample with me, they color-matched it and prepared the paint). It is a white color anyways. However after I applied a first…
Mark
  • 1,269
  • 4
  • 20
  • 39
13
votes
20 answers

Expedient repair for water damaged drywall behind tile

I set out to repair cracked grout at the top of a course of tiles on the wall immediately above my bathtub. After scraping out all the damaged grout I discovered that the only other thing holding the tiles in place was the caulking between them and…
zwol
  • 264
  • 1
  • 2
  • 9
10
votes
8 answers

Where do you cut drywall if you need to remove it but still want to easily put it back up?

I want to pull a section of drywall down, but then put it back up again later. I'm having a hard time deciding where to cut. I think ideally, I could cut exactly down the center of a stud so that I could screw it back in. But there will already be…
brentonstrine
  • 970
  • 3
  • 14
  • 27
8
votes
5 answers

Can blue (lightweight) drywall compound be used for all coats?

I had a guy come in to do some drywall taping today and I had a bag of 20 min hot mud and a bucket of each green (regular) and blue (lightweight) joint compound. I always though that the green should be used for the first two coats cause it is…
amphibient
  • 7,095
  • 42
  • 115
  • 182
8
votes
3 answers

Spackling drywalls around plumbing pipes

What’s the best way to fix drywall holes ~1-1.5” on each side around pipes coming into the wall under sink. I’ve seen folks foam the holes around pipes, but it looks ugly. I was thinking to patch with spackling patch, but this would most likely…
Tagar
  • 281
  • 3
  • 14
8
votes
4 answers

Fix drywall that lost strength due to hanging curtain rod

Here is the issue. I can use the toggle bolts, but it looks like drywall has lost strength. It can be seen in the pictures that drywall around the place of the bracket holes is swelled and about to come off.
user6579904
  • 83
  • 1
  • 1
  • 4
7
votes
9 answers

How do I cover large gaps in drywall?

We've just completed our first drywall project and the outcome wasn't so great in places. There are a couple spots in particular that have 1/2-1/4" gaps. I was wondering, is there a nifty way to close these gaps or do we have to pull the panel down…
javamonkey79
  • 173
  • 1
  • 1
  • 5
7
votes
2 answers

Why are there two layers of dry wall in my ceiling, and how can I patch it?

The fan in my bathroom died. We bought a replacement that's a bit bigger. The original was nailed to a beam in the ceiling and required me to cut out some drywall to remove. When removing the old fan, the air duct came loose. I need to open up the…
MicronXD
  • 195
  • 1
  • 2
  • 5
1
2 3
…
13 14