What type of backer board do I need to use to attach a stone veneer around a fireplace?

Question

I want to put up a stone veneer surround, around a gas fireplace we're going to install. I've seen everything from using 1/2" plywood and a metal lath, to putting the tiles directly on drywall. I have everything apart so I want to do this the best way.

The tiles/stones I will be using are quite heavy as they are real stone and not "manufactured stone".

Items in play: - Weight - heavier tiles - heat - over and around a fireplace - Indoor

Tester101 · Answer 1 · 2011-01-14T12:55:14.730

5

Drywall is out of the question due to weight, plywood might not give you the proper adhesion.

I would start with cement board, then attach the metal lath to that. After the metal lath is secure, you'll have to apply a scratch coat of a sand and cement mix before applying the stone.

Here is a good guide for applying stone veneer.

edited Jan 14 '11 at 12:55

answered Jan 13 '11 at 15:20

Tester101

130,386
77
314
605

2

definitely start with a concrete board backer, avoid plywood in areas that may have heat issues, two reasons, fire danger and excessive expansion or contraction due to wide ranges of temp. – shirlock homes Jan 14 '11 at 07:30
Good point shirlock, I overlooked that he was installing it near a fireplace. – Tester101 Jan 14 '11 at 12:54
No problem tester, you are usually right on. – shirlock homes Jan 14 '11 at 19:53

score 3 · Answer 2 · answered Mar 12 '16 at 04:31

If you are using real Stone, one thing to consider, the wall doesn't support the weight , it just hold it from moving horizontally, any real Stone need a firm base to sit on like a heart or Concrete slab like your floor . This is called vertical load. The only attachment you need on the wall is a wall tie and a 8 penny nail. There should always be a hollow cavity behind the stone when laying. The wall tie is the mechanical anchor that transfers to the wood stud framing or shear wall. Fake Stone or stucco Stone is a totally different application, where cement board or lath is more commonly used.

score 1 · Answer 3 · edited Dec 11 '15 at 15:19

If you use cement board, you'll want to use a polymer modified mortar or thinset for the installation. If you use plywood, you'll need to install a weather resistant barrier, metal lath and put up a scratch coat. They both have there pros and cons, but I would probably recommend cement board. Make sure its actually cement board and not a composite board like hardybacker. Unfortunately stone veneer tends to sheet off on composite board unless it's installed with a very good bonding mortar or thinset.

What type of backer board do I need to use to attach a stone veneer around a fireplace?

3 Answers3