0

I have a self-tapping screw that has stripped through its plastic (I can't be more specific) housing. What's the toughest (as in resistant to stripping, it's not particularly load bearing) glue that I can fill it with, and still be able to drive it in once set? (I do need to be able to remove it again.)

For example, a two-part epoxy would be nice and strong, but it wouldn't tap. A 'hot melt' stick would be easy, but I'm not convinced it would hold well; likewise a silicone sealant or caulking. A PVA wood glue should be possible to screw into, but I think it might just start to crumble rather than hold a thread? Perhaps 'Gorilla Glue'?

OJFord
  • 155
  • 1
  • 9
  • 1
    A good way to be "more specific" is to post a picture. If we can see the screw and the hole it came out of this will help us understand the situation. – tnknepp Aug 27 '21 at 18:35
  • It might help to include a picture of the part with the stripped hole, as well as indicating the _type_ of plastic. Different plastics can require different techniques. – FreeMan Aug 27 '21 at 18:35
  • @tnknepp jinx! :) – FreeMan Aug 27 '21 at 18:35
  • 1
    Use a an epoxy compatible with the plastic, then once it's set drill a hole slightly smaller than the shaft of the screw. – brhans Aug 28 '21 at 01:47

2 Answers2

1

I would drill out the plastic and glue in a plastic rod of a suitable diameter then re-drill the hole as necessary.

This does of course depend on the thickness of the material that is being worked with.

Another option is to glue a fresh piece of plastic behind to give more support to the screw.

Solar Mike
  • 24,863
  • 2
  • 28
  • 57
  • Yes, unfortunately it's very small, and no (convenient) access behind. I jumped to glue thinking that would be an easy way of filling it with plastic, just formed in situ. – OJFord Aug 27 '21 at 18:53
  • To be honest if I had room to do this without splitting the plastic that remains I'd just set a nut or threaded insert in there. – OJFord Aug 27 '21 at 19:58
0

Use the two part epoxy and drill a pilot hole for the self-tapper to get started in. Take care to only drill through the material, as there may be something beneath that doesn't like being drilled at the same time.

Tim
  • 4,905
  • 11
  • 28