How should I attach crown molding to cabinets with limited space?

Question

I am putting up some crown molding on top of some existing cabinets, but I only have about 12 inches of clearance. In the past when I have done projects like this, I have used a finishing nailer or brad nailer, however with this space, the tool won't fit.

What options or tool can I use to attach crown molding in this limited space?

Steven · Answer 1 · 2012-03-18T21:23:00.483

5

You could use a good construction adhesive to glue it in the areas you cannot drive a nail through. Make sure to use a scrap piece of molding to wedge the piece against the wall until the glue dries.

edited Mar 18 '12 at 21:23

answered Mar 18 '12 at 14:44

Steven

27,426
9
51
86

I was putting crown molding on the top of a cabinet and not attaching to the wall, but thanks for the idea. – KodeTitan Mar 19 '12 at 06:18

score 4 · Accepted Answer · answered Mar 18 '12 at 20:22

You can also use a nail spinner on the end of a drill. It's a small tool that chucks into the drill. Put a nail into the end of it and it spins it into wood. A final tap with a nail set puts the nail below the surface. It's a cabinetmakers tool and it prevents splitting the wood when driving finish nails into moldings (particularly oak).

http://www.craftsman.com/craftsman-nail-spinner/p-00902601000P

I wouldn't recommend using the palm nailer.... They're not easily controlled and you risk damaging the molding itself.

In this case, to get the crown molding on top of the cabinet, I used a 90 degree drill (only needed 4 inches of clearance) and screws to get it in. I did this before I knew about the nail spinner and will add that to my list of things to try next time. — KodeTitan, Mar 19 '12 at 06:15

score 2 · Answer 3 · edited Feb 07 '19 at 17:54

2

A palm nailer might work for this.

Palm Nailer Image

edited Feb 07 '19 at 17:54

Glorfindel

1,173
2
14
20

answered Mar 18 '12 at 00:26

mikes

11,135
1
19
30

1

I did try the palm nailer, but as someone mentioned, I ran into problems. First I bought a cheap one which had its issues. I then bought a Rigid that worked much better and I had some better control, but the wood was too hard for nailing. I kept bending nails. In the end a 90 degree drill and screws did the trick with pre drilled guide holes. – KodeTitan Mar 19 '12 at 06:16

Steve Fallows · Answer 4 · 2012-03-18T15:10:07.153

1

I have the Rigid JobMax multi-tool with the Auto-Hammer head, which works in tight spaces. You'll have to set the nails below flush by hand though.

edited Mar 18 '12 at 15:10

answered Mar 18 '12 at 04:09

Steve Fallows

873
2
11
18

How should I attach crown molding to cabinets with limited space?

4 Answers4