Home Improvement Stack Exchange
Home Improvement Stack Exchange

Questions tagged [mwbc]

Use this tag for questions about Multi-Wire Branch Circuits, sometimes called "Edison circuits".

A multi-wire branch circuit is used to conserve wire in North American wiring when dual (line to line and line to ground) utilization voltages are present, such as in the 120/240V split-phase system used in residences or Wye type three phase systems (120/208Y, 277/480Y) found in commercial work.

These require a common disconnecting means (either a pullout disconnect with multiple fuses, multiple single pole breakers linked by handle ties, or a multi-pole breaker), and the neutral must be pigtailed to wiring devices so that removing a device does not unlink the neutral. They are most commonly used for kitchen receptacles (small appliance branch circuits), despite having compatibility issues with and most protection, but may be used for other things as well.

65 questions
37
votes
2 answers

What is a tandem breaker (aka duplex, cheater, twin, double-stuff, etc.)?

I keep hearing about tandem breakers, and how they won't work with 240V loads and how they should never be used for a multi-wire branch circuit. Aside from those issues... What is a tandem breaker? (note: they can be thrown independently).
Harper - Reinstate Monica
  • 276,940
  • 24
  • 257
  • 671
15
votes
4 answers

I installed a new outlet and tripped the whole power panel... Does a 30 amp circuit need special outlets?

So... I tried swapping two outlets in my kitchen, and tripped the entire power panel! The old outlets were wired with FOUR wires: red, black, white, bare. I wired the new outlets using the same scheme: Red to one of the HOT terminals Black to the…
steeveedee
  • 151
  • 1
  • 4
9
votes
3 answers

Splitting 240V into two 120V Circuits

I think I have this figured out for the most part but looking for validation from expert strangers on the internet. Renovated the kitchen in this 1960's house. I think it probably has been renovated before and there was a ton of power in the…
Tyler Herron
  • 91
  • 1
  • 3
8
votes
3 answers

Neutral pigtails on MWBC

I've recently moved into a new home with a few outbuildings. Due to the property being in rural unincorporated area, no inspections or permitting was required on the outbuildings when they were built last year. To mitigate the risk my insurance…
cyclops
  • 837
  • 1
  • 9
  • 18
7
votes
1 answer

House Wired Incorrectly? - MWBC

I am working on finishing my basement. In my basement there is 3 junction boxes fed by 12/3 wire. Each junction box feeds a single 12/2 line (White-White, Black-Black, Ground-Ground, Red-Nothing). My thought was this was done to allow expansion at a…
Jeff
  • 71
  • 1
7
votes
1 answer

Why are tandem breakers on shared neutral (MWBC) problematic?

I hear that shared-neutral or multi-wire branch circuits (MWBC) can have issues when used with tandem breakers (also called duplex, twin, cheater or double-stuff breakers). What is the issue there? Also, how do I put them on GFCI or AFCI?
Harper - Reinstate Monica
  • 276,940
  • 24
  • 257
  • 671
6
votes
2 answers

Look over father's plan to fix outdoor electrical circuit

So to begin with, I am not a DIY'er when it comes to electricity. I prefer to allow the professionals to handle these matters as it's not something I'm confident in and not too knowledgeable about... my dad however has always been a DIY'er and I'll…
Austin Stepp
  • 61
  • 2
5
votes
2 answers

Sharing Neutrals - How To Correct?

I have a 12/3 NM cable landing on two separate 20 amp breakers sharing a neutral between the two. They are landing on a Dishwasher/Garbage Disposal outlet. I understand this is NOT to code since there is no tie bar between the two breakers (confirm…
Richard
  • 443
  • 2
  • 13
5
votes
1 answer

MWBC with both circuits on the same bus -- any easy fixes?

While moving some wires around in my garage (to make space for attic storage), I discovered an electrical issue that might be concerning: In my garage there are two circuits delivered as a MWBC, but the two circuits are on the same bus (0V between…
ldoogy
  • 153
  • 4
5
votes
3 answers

Multi-Wire Branch Circuit on wrong breakers

My electrical panel has a double-pole breaker that looks like it's for a MWBC, but actually the attached wires are from different cables. In the below picture the black wire with the yellow rubber bands goes out the side of the panel (to a sump…
IceGlasses
  • 163
  • 5
5
votes
2 answers

In a multiwire branch circuit, can the two hots be connected to the same phase?

This may be an obvious question, but I haven't been able to find a direct answer. I believe I have a MWBC - I have two hot wires connected to two separate circuit breakers, sharing a neutral and ground wire. The two circuit breakers are not adjacent…
Mwinn
  • 51
  • 2
5
votes
2 answers

MWBC (Multi-Wire-Branched-Circuit) w/out joined breakers, how best to fix?

I was trying to replace a fan/light in my living room with a new led light, and have found that the living room branch circuit (lights and outlets) is actually fed by a Multi Wire Branch Circuit (14-3) that powers both the living room and a second…
Mr McBanners and Cheese
  • 53
  • 1
  • 6
5
votes
2 answers

Change from 240V to 120V

I did quite a bit of research including on this forum but wanted to double check if I got things right. On the outside of our home there is a standard electrical box (guessing about 3"x5") to install an outlet. There is no outlet yet but just a…
Hu F.
  • 51
  • 1
  • 4
5
votes
2 answers

Can I use a ground rod as an equipment ground for a detached garage?

I'm in a bit of a dilemma. The house we bought has a detached garage supplied by 12/3 UF with ground. The previous owner/handyman set this up as a multiwire branch circuit (MWBC) with a twist: one of the conductors is fed from the main panel in…
benjamin
  • 51
  • 1
4
votes
2 answers

Can you cut the outlet-bridge clip and run a 2-phase MWBC to a single receptacle?

Many outlets have a bridge clip on each side of the receptacle. (I have seen these used for things like making one outlet switched on one side but always-on for the other.) Question: If you have a handle-tied 2-pole breaker, can you cut the hot…
KJ7LNW
  • 1,025
  • 5
  • 17
1
2 3 4 5