Questions tagged [cistern]
27 questions
4
votes
1 answer
How can I open an older type Gustavsberg cistern toilet?
Can anybody advise how to open this type cistern...? I tried to loosen nut on top but did not want to force it.
Thanks
Markoca
- 49
- 3
4
votes
3 answers
Can I glue the float back onto linkage to my toilet fill valve?
The part (circled in red) has snapped off - I think it belongs to the entry fill valve. I have placed the knife in there to stop the cistern from filling and overflowing.
Should I try and super glue the black bit attached to the metal connector (at…
JJT
- 143
- 4
2
votes
0 answers
I have an old porous "fruit cellar" of stone/concrete mix crumbling apart. How can I close it off and fill it in? Same with an old leaky cistern
Our house is almost 100 and has a fruit cellar crumbling below our front porch. We had it repaired 3 times but given it is made of a stone/concrete mix the foundation repairs continue to crumble & leak. The floor is very porous and eventually drains…
Ken Brooks
- 21
- 1
2
votes
2 answers
Reduce speed of existing well pump
My existing well pump (at 550 ft deep) is a nearly brand new (installed last July) 3 wire pump and I do not want to replace it. However, I now have a 1500 gallon underground cistern in which to store water. I can use the existing pump just fine, but…
David Pfeffer
- 879
- 4
- 14
- 31
1
vote
2 answers
Replacing Ceramic Toilet Cistern
I have a damaged toilet cistern which is beyond repair. I was wondering if I was to install a new cistern how I would know my new one would be 'compatible' with my current set up? Is there a degree of standardisation such that I can be guaranteed I…
SteveCallender
- 11
- 2
1
vote
1 answer
Fixing an inwall toilet constantly flowing
I have a Schwab inwall toilet. Water keeps flowing heavily after flushing.
I took everything out of the wall and found that the reason is because the ?hammer doesn't come back up again, therefore the ?float never thinks that it is full.
The reason…
user2029763
- 13
- 2
1
vote
1 answer
No cold water in toilet tap or cistern
Please forgive me if I get any terminology wrong here, I know nothing about plumbing…
We have suddenly stopped getting cold water in our downstairs bathroom and cistern. No issues with hot water anywhere.
We tried holding our hand over the tap and…
K Mac
- 19
- 1
1
vote
1 answer
How does a drain back valve / Bleeder Orifice for winterization work on a foot valve water pump system which might have air leaks?
I have cistern which is filled either by truck or pumped from the lake. To connect to the cabin, there is a pipe with a foot valve at the bottom, and a pump with a pressure tank at the bottom of the cabin.
My setup is a bit different since we don't…
Greg Gunningham
- 23
- 4
1
vote
0 answers
Concealed toilet cisterns attached by screws to dry wall. Are they secure?
I've noted several post-2000 build apartments that have concealed plastic toilet cisterns that are secured at the rear to dry wall by 4 screws. They are lever-type cisterns, so there is also a toilet lever tube (either metal or rigid plastic)…
Brybeck
- 951
- 2
- 8
- 18
1
vote
0 answers
(UK) Toilet flush makes a vibrating, grinding sound just at the start of filling
I had a bathroom renovation including totally new toilet (using the existing plumbing) with new cistern, pan, etc.
After installation, but not immediately, I started having this vibrating / grinding sound in the pipe after flushing, it happens just…
seventyeightist
- 173
- 1
- 10
1
vote
1 answer
Is it normal for a siphon in a toilet cistern to tilt to the side when the toilet is flushed?
I've noticed some cisterns have siphon units that are not secured at the top. Every time the toilet is flushed, the top of the siphon moves or tilts to one side. For example, in the following youtube…
Brybeck
- 951
- 2
- 8
- 18
1
vote
1 answer
Braided stainless steel water supply hoses versus rubber hoses
I've noticed some apartments that use both for water supply to faucets and toilet cisterns.
I understand that the braided hoses are rated for higher pressures, but how do they compare in terms of durability at typical static and dynamic…
Trend2019
- 81
- 1
- 4
1
vote
0 answers
Broken rubber seal - leaking toilet cistern
The black rubber dome on the underside of my toilet cistern cracked and flooded my bathroom.
What's it called?
What's it for?
What measurements do I need to make to buy a new one?
What tools do I need to replace it? (I tried to turn the hexagon…
Irfan434
- 111
- 1
1
vote
2 answers
Solar powered water pump
I have really low water pressure in my home at about 15 PSI and sometimes even 0. I already have a check valve on my main 3/4" line from the water meter. Since electricity is pretty expensive where I live (about $0.35/KWH) and also goes out…
Rick
- 857
- 7
- 19
- 32
0
votes
0 answers
Water pump electricity
Where I live, the water pressure from the water utility is very low (About 8 PSI average). I am considering getting a jet pump with a 33 gallon pressure tank and a 400 gallon water tank for when there is no water at all. Electricity is a major…
Rick
- 857
- 7
- 19
- 32